Service Manual • ScanMate 4000/5000 Edition 1 • January 1996
3•4
3 • SERVICE PROGRAM
The monitor program can be copied to the hard disk by typing:
C:
CD\
MD SCANMATE
CD SCANMATE
COPY A:\SCANMATE.EXE
Now go to the appropriate directory:
C:
CD \SCANMATE
Run the monitor program by typing:
SCANMATE.EXE /5000
If COM2 is used, type:
SCANMATE.EXE /5000 /2
Turn on power on the scanner and the following will be shown on the
screen:
**********************************************
* 9600 Baud communication utility *
* Version 1.0.2. *
* <F3> for logfile *
* <F10> for Exit *
**********************************************
COM 1 is used
9600 Baud communication utility:
indicates that the program is actu-
ally just a communication utility showing the baud rate.
Version 1.0.2: is the version number of the monitor program.
<F3> for logfile: to create a logfile that contains a transcript of all
communication between the scanner and the monitor program, press
F3. The monitor program then asks for a file name for the log file. Enter
a file name, for instance scanmate.log , and press Enter. All that is writ-
ten to the screen is also written to the file. To stop the monitor program
from logging data, press F3 again.
<F10> for exit: quits the program. Press F10 and the DOS prompt is
shown again.
Note: always remember to terminate the log file mode before the moni-
tor program is terminated, otherwise the content of the log file will not
be correct.
To Next Page
Loading...