Function
The DC motor is common to the ScanMate 4000 and 5000 (both 0200
and 0210 models). It rotates the drum and feeds position data back to
the control circuits.
Technical data
24V Maxon DC motor, with Stegmann encoder giving 1 sync pulse/rev.
and 5000 clock pulses/rev.
Tools and materials required
4 mm set screws (2)
1.5 mm allen key (new or re-ground) for motor set screws
2.5 mm allen key for DC motor covers mounting screws
3 mm allen key (T-handle) for left hand drum cover mounting screws
3 mm allen key for drum end plate and motor mounting screws
Loctite 243 or equivalent for set screws
Tape for sealing set screw access hole
4 • PART REPLACEMENT
PN 960 20 000 80 (4000 and 5000) DC Motor
Edition 1 • January 1996 Service Manual • ScanMate 4000/5000
4•15a
Caution! ☛ Turn off power • Before connecting or disconnecting cables.
• Before carrying out service operations.
☛ A 1.5 mm allen key in good condition is essential for removal and
fitting of the two motor shaft set screws as they are in a difficult
position to remove if they become rounded. (If the holes become
rounded, a 1/16” allen key may help to remove them).
To Next Page
Loading...