Product Description
BAJR_USA_EN_V03 Page 3-11
3.4 Special settings
Note:
All settings described in this section can only be programmed by an authorized service
technician.
3.4.1 Service reminder
After a certain number of products a reminder will be displayed that it is time to have
the machine serviced.
3.4.2 Cleaning settings
3.4.2.1 Cleaning reminder
After 250 product servings the display will show the following:
Note:
The LED (red) next to the
[
]
button will flash. The LED will stop flashing as soon as
the cleaning is completed.
Products can be served again.
The cleaning reminder can be enabled by the service technician according to the
client's wishes. After the display message "Cleaning" appears for the first time, up to
50 products can be served until the machine locks itself to force a cleaning of the sys-
tem.
Should the machine be cleaned before the cleaning reminder appears, displaying the
reminder will be suppressed.
Note:
The service technician can set the number of product servings between 1 and 999 be-
fore the cleaning reminder appears for the first time.
3.4.2.2 Coffee system flush
The automatic flushing is designed not only to clean the system but to ensure a regular
internal maintenance (turn-off flushing) of the machine and optimum quality of the first
coffee served (turn-on flushing).
The machine can be configured by the service technician to enable the desired flush
types.
3.4.2.2.1 Turn-on flushing
The automatic flushing program is run after the coffee machine is switched on.
After the turn-on flush cycle is complete and the system has warmed up the machine is
ready to serve. The turn-on flush will last approx. 40 seconds.
Danger!
The machine will automatically start as soon as the turn-on flush is activated.
Keep hands away from the beverage outlet!
Reinigung