Schaerer Junior - Page 67

Error Messages and Malfunctions
BAJR_USA_EN_V03 Page 6-3
"Grinder block."
(sTxt-044)
- An object (e.g. a stone) is stuck in the
grinder.
No coffee can be served.
- Using the [on/off] button, switch the ma-
chine off and on and press the product
button again.
-
If the message persists, disconnect the
coffee machine from the power mains.
Vacuum the coffee beans out of the grind-
er. Check the grinder for stuck objects.
-
If the problem still persists, contact an
authorized service.
"
Heating
"
Green LED does not
illuminate
(Txt-000)
- When the coffee machine is switched on,
no products can be served until the sys-
tem warms up.
The coffee machine cannot be operated.
- You can serve coffee and hot water prod-
ucts after approx. 5 minutes.
- Check the phase fuse.
- If the message persists, contact an autho-
rized service.
"Level"
(sTxt-049)
-
The water level in the steam generator
has not been reached after 90 seconds.
The coffee machine cannot be operated.
-
Check whether the stop valve of the water
mains is open.
- Press the [on/off]
button twice to switch
the machine off and on again.
-
If the problem still persists, contact an
authorized service.
"Motor control"
(sTxt-053)
- Control defective.
The coffee machine cannot be operated.
- Contact a customer service authorized by
the manufacturer.
"No beans"
Red LED illu-
minates
(Txt-040)
- One of the beans containers is empty.
-
An object (e.g. a stone) is stuck in the
grinder.
No coffee can be served.
-
Refill with max. 0.75 kg coffee beans (per
container) and press the product button.
- Press the product button again.
If the message persists, disconnect the
coffee machine from the power mains.
Vacuum the coffee beans out of the grind-
er. Check the grinder for stuck objects.
-
If the problem still persists, contact an
authorized service.
"NTC-Steam"
(sTxt-050)
- The temperature sensor in the steam
generator is defective.
Steam discharge is blocked.
- Contact a customer service authorized by
the manufacturer.
"NTC-Water"
(sTxt-051)
- The temperature sensor in the instant
heater for coffee water and
hot water is
defective:
No coffee can be served.
- Contact a customer service authorized by
the manufacturer.
"Prod.Data Err!"
(Start up)
Product button checksum error.
The coffee machine can be operated.
-
Contact a customer service authorized by
the manufacturer.
"Service !!!"
(sTxt-058)
- The programmed number of beverages
has been served or the programmed time
limit for the next maintenance has been
reached.
Products can still be served.
- Contact an after-sales service au-
thorized by the manufacturer.
"Sys.Config.Err!"
(Start up)
- General settings checksum error.
The coffee machine can be operated.
- Contact a customer service authorized by
the manufacturer.