SCW Sentry Pro - Configuring 802.1 X Settings

UserManualofIRNetworkSpeedDome
39

2. Checkthecorrespondingversioncheckbox( ,
, )toenablethefeature.
3. ConfiguretheSNMPsettings.
Note:TheconfigurationoftheSNMPsoftwareshouldbethesameasthesettings
youconfigurehere.
4. Click  tosaveandfinishthesettings.
6.3.6 Configuring802.1XSettings
Purpose:
ThespeeddomesupportsIEEE802.1Xstandard.
IEEE802.1XisaportͲbasednetworkaccesscontrol.Itenhancesthesecuritylevelof
the LAN. When devices connect to this network with IEEE 802.1X standard, the
authenticationisneeded.Iftheauthenticationfails,thedevicesdon’tconnecttothe
network.

TheprotectedLANwith802.1Xstandardisshownasfollows:

Figure6Ͳ16 ProtectedLAN
z BeforeconnectingtheNetworkCameratotheprotectedLAN,pleaseapplya
digitalcertificatefromaCertificateAuthority.
z The network FDPHUD UHTXHVWV DFFHVV WR WKH SURWHFWHG /$1 YLD WKH
Authenticator
Authentication
Server