SCW Sentry Pro - Configuring OSD Settings

UserManualofIRNetworkSpeedDome
51
ShortIlluminationDistance
LEDsON
Callpre set122. ThefourIRLEDsinthe
secondandthirdrowsareturnedon.
AllLEDsON
Callpre set123. AlltheIRLEDsareturned
on.
AllLEDsOFF
Callpre set124. AlltheIRLEDsareturned
off.

FanandHeaterMode
Call the systemͲdefined presets to adjust the mode of fan or heater. The
correspondingmodesandpresetsareasfollows:
Mode Description
FanONbyTemperature
Control
Callpre set125.Thefaniscontrolled
automaticallybythetemperatureinthe
speeddome.
FanON Callpre set126. Turnonthefan.
FanOFF Callpre set127.Turnoffthefan.
HeaterONbyTemperature
Control
Callpre set128. Theheateriscontrolled
automaticallybythetemperatureinthe
speeddome.
HeaterOFF Callpre set129. Turnofftheheater.

6.5.2 ConfiguringOSDSettings
Purpose:
Thespeeddomesupportsfollowingonscreendisplays:
Time:Supportsfortimedisplay.
CameraName:Identifiesthenameofspeeddome.

Youcancustomizetheonscreendisplayoftime.
Steps:
1. EntertheOSDSettingsinterface:
Configuration>AdvancedConfiguration>Image>OSDSettings