SCW Sentry Pro - Configuring Snapshot Settings

UserManualofIRNetworkSpeedDome
63
Figure6Ͳ46 EmailSettings

2. Configurethefollowingsettings:
Sender:Thenameoftheemailsender.
Sender’sAddress:Theemailaddressofthesender.
SMTPServer:TheSMTPServerIPaddressorhostname(e.g.,
smtp.263xmail.com).
SMTPPort:TheSMTPport.ThedefaultTCP /IPportforSMTPis25.
EnableSSL:CheckthecheckboxtoenableSSLifitisrequiredbytheSMTP
server.
AttachedImage:CheckthecheckboxofAttachedImageifyouwanttosend
emailswithattachedalarmimages.
Interval:Theintervalreferstothetimebetweentwoactionsofsendingattached
pictures.
Authentication(optional):Ifyouremailserverrequiresauthentication,check
thischeckboxtouseauthenticationtologintothisserverandenterthelogin
usernameandpassword.
Receiver:Selectthereceivertowhichtheemailissent.Upto2receiverscanbe
configured.
Receiver:Thenameoftheusertobenotified.
Receiver’ sAddress:Theemailaddressofusertobenotified.
3. Click  tosavethesettings.
6.6.7 ConfiguringSnapshotSettings
Purpose:
You can configure the scheduled snapshot and eventͲtriggered snapshot. You can
uploadthecapturedpicturestoaFTPserver.
BasicSettings
Steps:
1. EntertheSnapshotSettingsinterface:
Configuration>AdvancedConfiguration>Events>Snapshot 
2. Check the Enable Timing Snapshot checkbox to enable continuous snapshot.
Check the Enable EventͲtriggered Snapshot checkbox to check eventͲtriggered
snapshot.
3. Selectthequalityofthesnapshot.
4. Setthetimeintervalbetweentwosnapshots.
5. Click  tosavethesettings.

UploadingtoFTP
Note:PleasemakesurethattheFTPserverisonline.