CAR (vehicle settings)152
– Press the button ⇒ page 151, fig. 191 to fold open the
display.
– Check whether there is already a DVD or CD in the drive. If there
is a DVD or CD in the drive, press the eject button and remove it
⇒ page 24.
– Insert the up-to-date navigation DVD into the drive, keeping it
level (printed side faces up). Hold the navigation DVD at the
centre hole and at the outer rim. The navigation DVD will be
drawn into the drive automatically. The update will start automat-
ically ⇒ page 151, fig. 192.
– Switch the navigation system on manually ⇒ page 4 once the
update has been completed.
When it is inserted the navigation DVD will first be checked. When the check
has been completed you can monitor the progress of the software update by
means of the graph shown in the display ⇒ page 151, fig. 192. The graph will
show approx. 10% ⇒ page 151, fig. 192 while it is deleting the old software.
Once the software update has been completed the navigation system will re-
start automatically. If necessary the audio software will then also be updated.
The display will show a message. When the complete software update has
been finalised the navigation system will be switched off. Switch the naviga-
tion system on manually ⇒ page 4.
Note
• Switch on the engine before you start the update in order to avoid
draining the battery.
• When you insert the DVD for the first time, new software for the navigation
system will automatically be installed.
A
2
media_systemE_EN.book Seite 152 Montag, 21. September 2009 1:48 13
To Next Page
Loading...
