Repeater ID: This entry selects which BB3 unit to use as the repeater.
OK: click OK to leave this menu.
To select the units, click on Units from above.
Click on the group that is being modified.
If no decoders show up, select Add New Decoder and add units.
Place in the Unit ID desired. Select Type, BB3. If a name is desired for the shooter, place in
Driver/Shooter. Click on Add.
Select the BB3 ID desired for this group.
After the units are completed in the groups, click on the X in the upper right corner of the menu to
exit.
To create a dynamite process, select File, Process Maintenance.
To Next Page
Loading...