10C
24
Note:
1. If the Bluetooth connection between the headset and a mobile phone is
disconnected, tap the Phone Button to recover the Bluetooth connection
immediately.
2. If the Bluetooth connection between the headset and a media player is
disconnected, press the Jog Dial for 1 second to recover the Bluetooth
connection and play.
6.2 Second Mobile Phone Pairing - Second Mobile
Phone, GPS, and SR10
Typical Bluetooth headsets can connect with only one Bluetooth
device, but a second mobile phone pairing allows the headset to
connect with another Bluetooth device such as a second mobile
phone, an MP3 Player, or the Sena SR10, the Bluetooth adapter.
1. To pair the second mobile phone, press and hold the Jog Dial for
5 seconds until the red LED ashes rapidly and you hear a voice
prompt, “Intercom pairing”.
2. Within 2 seconds, tap the Phone Button again, then the LED
ashes blue rapidly and you will hear a voice prompt, “Second
mobile phone pairing”.
3. Search for Bluetooth devices on your mobile phone. Select the
Sena 10C in the list of the devices detected on the mobile phone.
4. Enter 0000 for the PIN. Some mobile phones may not ask for the
PIN.
5. The mobile phone conrms that the pairing is completed and the
10C is ready to use. You will hear a voice prompt, “Your headset
is paired”.
To Next Page
Loading...
Need help?
General
