10C
46
Note:
1. You can save FM stations to presets before using FM radio. Connect the
10C to your PC and open the Sena Device Manager. It allows you to save
up to 10 FM station frequency presets on the 10C settings menu. You
may do the same operation by using the Sena Smartphone App.
2. You can still answer an incoming phone call and intercom while listening
to the FM radio.
13.4 Scan and Save
“Scan” is the function that automatically searches station frequencies,
starting from the current frequency and up. To use the scan function,
please follow the procedures below:
1. Double tap the Phone Button. Then the current station frequency
moves upward to nd other station frequencies.
2. If the tuner nds a station, it stays at the station frequency for
8 seconds, then scanning to the next station frequency.
3. Scan function stops when you double tap the Phone Button again.
4. To save a station while scanning frequencies, tap the Phone
Button when at that station. You will hear a voice prompt from
the 10C, “Save preset (#)”. The station will be saved as the next
preset number.
5. All stations preset during “Scan”, will overwrite previously set
stations.
13.5 Temporary Preset
With the temporary preset function, you may temporarily preset
stations automatically without changing the existing preset stations.
Tap the Phone Button three times to automatically scan for 10
temporary preset stations. The temporary preset stations will be
cleared when the system is powered off.
13.6 Region Selection
You can select the proper FM frequency region from the Sena Device
Manager. With the region setting, you may optimize the seek function
to avoid unnecessary frequency ranges (factory default: worldwide).
Region Frequency Range Step
Worldwide 76.0 ~ 108.0 MHz ± 100 kHz
Americas 87.5 ~ 107.9 MHz ± 200 kHz
Asia 87.5 ~ 108.0 MHz ± 100 kHz
Australia 87.5 ~ 107.9 MHz ± 200 kHz
Europe 87.5 ~ 108.0 MHz ± 100 kHz
Japan 76.0 ~ 95.0 MHz ± 100 kHz
To Next Page
Loading...
Need help?
General
