Sena 10C - Fault Reset; Factory Reset

10C
62
18.3 Fault Reset
When the 10C is not working properly or is in faulty status for any
reason, you may reset by pushing the Pin-hole Reset Button at the
back of the headset main unit. Insert a paper clip into the reset pin-
hole and press the reset button for a second with light pressure. The
10C will be switched off. Restart the system and try again. This will not
restore the headset to factory default settings.
18.4 Factory Reset
1. To restore the 10C to factory default settings, press and hold the
Phone Button for 10 seconds until the LED shows solid red and
you hear “Factory reset”.
2. Within 10 seconds, press the Jog Dial to conrm reset. The headset
will be restored to factory setting and switched off automatically.
You will hear “Headset reset, good-bye”.
3. If you press the Phone Button or leave the Jog Dial for 10 seconds,
the reset attempt is cancelled and the headset returns to stand-by
mode. You will hear a voice prompt, “Cancelled”.