10C
64
Type Function Button Command LED Beep
Intercom
Start Group
Intercom
Press the Jog Dial for
3 seconds
Green
ashing
-
End Group
Intercom
Press the Jog Dial for
1 second
- -
Music
Play/pause
Bluetooth music
Press the Jog Dial for
1 second
-
Mid-tone
double beep
Track forward/back
Rotate the Jog Dial while
pressing
- -
FM Radio
FM radio on/off
Press the Phone Button for
2 seconds
-
Mid-tone
double beeps
Select preset Tap the Phone Button -
Mid-tone
single beep
Seek stations
Rotate the Jog Dial while
pressing
-
High tone
triple beeps
Scan up FM band Double tap the Phone Button - -
Stop scanning Double tap the Phone Button -
High tone
double beeps
Save preset while
scanning
Tap the Phone Button -
High tone
double beeps
Reset
Factory reset
Press the Phone Button for
10 seconds
Solid red
High tone
double beeps
Tap the Jog Dial within 10 seconds
Fault reset Press the Reset Button - -
CERTIFICATION AND SAFETY APPROVALS
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for
a Class B digital device pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment on and
off, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antennae
• Increase the separation between the equipment and the receiver
To Next Page
Loading...
Need help?
General
