Sencore MRD 5800 - Page 40

MRD 5800 – User Manual
Page 40 (116)
Service Lock Selection Menu
Setting
Range
Description
Selection Mode
Service Lock
PID Lock
Auto Seek
Setting to Service Lock sets the unit to
decode any PIDs associated with a service
number or service name. Setting to PID Lock
sets the unit to decode only the PIDs
specified in the PID Lock Configuration
matrix. Auto Seek mode will tune the unit to
the first service listed in the PAT if a transport
stream is present.
On Backup
Use Primary Service
Use Backup Service
Sets the service the MRD 5800 will tune to in
case of an input failover. If Use Primary
Service is selected the MRD 5800 will tune to
the service name specified in the Primary
section. If Use Backup Service is selected
the service name specified in the Backup
section will be tuned. How the MRD 5800
fails over inputs is configured in Section
4.2.1
Lock Mode
Service Name
Service Number
If set to Service Name the MRD will decode
only services matching the name specified
(SDT in DVB or TVCT in ATSC tables must
be present in this mode). If set to Service
Number the MRD will decode only services
matching the number specified.
Note: S302M Audio Type is now auto detected by the MRD5800
PID Lock Mode