OmniHub 6/6D– User Manual
Page 110 of 182
IP Output-Parameter Setting> On this page, there are three tabs where you can
modify the multicast IP, port and parameter of IP Output. There are Port 1, Port 2 and
Batch Setting. The output can accept Multicast or Unicast and support MPTS and
SPTS.
Port 1 shows the 16 channels. Check the box under Enable to enable a channel. Input
the correct Multicast/Unicast IP address, IP port and appropriate output bitrate, and
select the correct Protocol for the output IP. Once done, click Apply for the changes to
take effect. See the image below for reference.
3.5.8.2.3 Multiplexing
Multiplexing has four tabs: Source, Service Configuration, PSIP and PID
Transmission. Here you are can set to output services from IP Input to Modulation
Output. Click Multiplexing to see 32 modulation output channels. Select a channel you
want to configure and you will see Source setting of this channel.
To Next Page
Loading...
Need help?
General
