Sencore OmniHub 6 - Page 139

OmniHub 6/6D– User Manual
Page 139 of 182
the output stream
Source MAC Mode
Auto
Manual
When set to Auto, the source MAC address of
the output stream will match the
corresponding local interface. When set to
Manual, a user entered address can be
assigned to the output stream
Source MAC
xx:xx:xx:xx:xx:xx
The user defined MAC for when using Manual
MAC Mode
TS Packets Mode
Auto
Manual
In Auto mode, the source will define the
number of TS packets per IP packet. In
Manual mode, the user will define the number
of TS packets per IP packet
TS Packets per IP Packet
1-7
The number of TS packets that are contained
with a single IP packet. Default is 7. Lowering
this value below default increases network
overhead
Encapsulation
UDP
RTP
Sets the Encapsulation to UDP or RTP