OmniHub 6/6D– User Manual
Page 25 of 182
Basic Settings tab displays the configuration page of the IP input. You can enable the
TS and set the input IP Address, IP port and Protocol of the source multicast.
To enter many IP addressed for the inputs, click the Batch Setting button and fill
in the following fields. You can only set the source when the IP addresses are in a
consecutive order.
Click the Apply button on the right side to make the change takes effect.
Service Configuration tab displays the configuration page where you can manage the
received services and output them to their designated interface. Configuration steps for
IP input and all receiving and encoding modules in OmniHub 6/6D are mostly the same.
First, you need to the port on each TS with LOCKED signal status. Each
port might be scanned automatically or need to be scanned when its source signal is
replaced.
After scanning each channel, you can output each transport stream or service by
clicking the icon and below “Destination Settings”. You can route the whole
To Next Page
Loading...
Need help?
General
