Sencore OmniHub 6 - Page 96

OmniHub 6/6D– User Manual
Page 96 of 182
Modulation Output-Parameter Setting> On this page, you can enable channels as
you need and input the Frequency (KHz), QAM Mode, Symbol Rate (KBaud) and RF
Level Gain (dBmV) to have an output.
Here are the range parameters of the above info.
Parameter
Range
Frequency (KHz)
47000 ~ 999000
QAM Mode
QAM16, QAM32, QAM64, QAM128, QAM256
Symbol Rate (KBaud)
3600 ~ 6956
RF Level Gain (dBmV)
-10 ~ 0
(The value must be a number multiple of 0.5)
RF Level (dBuV)
90~120
PSI/SI Interval (ms)
50 ~ 10000
You can also set the RF level in a range of 90 to 120 as shown in the image below.