SERES 5 - Page 105

Assistant Driving 丨 105
1
2
3
4
5
6
7
8
9
10
11
12
13
* The image is for reference only; please refer to the actual
product
Set up the Driving Recorder through the Central
Control screen.
On the Central Control screen, you can adjust the
parameters of the Driving Recorder. Click the settings icon
on the real-time preview interface to enter the settings.
● Audio Recording During Video: Click the switch to
the icon to turn it on, enabling this function. Click the
switch again to turn it off and make the icon gray.
● Overlay Information: Users can overlay real-time
time and vehicle status information on video files and
control the switch.
● Delete Driving Recorder data: Clear all Driving
Recorder data from the USB flash drive
* The image is for reference only; please refer to the actual
product
● USB Interior Storage: View the usage of the USB
flash drive.
● Driving Recorder USB Usage: Insert the USB flash
drive into the USB port of the Driving Recorder for
storing photos or videos.
* The image is for reference only; please refer to the actual
product
Tip
• Do not plug or unplug the USB flash drive while it
is powered, as it may result in the loss of the last
few seconds of recording or even damage to the
USB flash drive.
Tip
• When the data on the USB flash drive is excessive
and the available capacity is low, the write speed
may decrease. It is recommended to back up the
data and format the USB flash drive through the
Central Control screen.
• It is advisable to use a USB flash drive exclusively
for the Driving Recorder. If the USB flash drive
contains too much user data (not used by the
Driving Recorder) and the remaining memory is
less than 2GB, the Driving Recorder may not
recognize the card.
● Data Export: Remove the USB flash drive from the
USB port and insert it into the computer for data
export.