SERES 5 - Wiper

Maintenance and Care丨 167
1
2
3
4
5
6
7
8
9
10
11
12
13
Wiper
The recommended frequency for wiper blade replacement
is once a year. Regularly inspect and clean the edges of
the wiper blades, check for cracks, fissures, or roughness
in the rubber. If abnormalities are detected, promptly
replace the wiper blades.
Replace the front wiper blades
1. Turn off the wiper function and switch the gear
position to Parking (P), then on the central control
screen, click on Vehicle Setting > Vehicle Condition
to enable the front wiper maintenance mode.
* The image is for reference only; please refer to the actual
product
2. Lift the wiper arm from the windshield glass.
3. Press the locking tab and slide the wiper blade out
from above the wiper arm.
* The image is for reference only; please refer to the actual
product
4. Install the new wiper blade.
5. Ensure that the wiper blade on the wiper arm is tightly
against the windshield glass.
6. If the issue persists after using a new wiper blade,
clean the windshield glass and wiper blade with a soft
cloth or sponge dipped in warm water with non-
detergent soap. If no water droplets form, it indicates
that the windshield glass is clean.
Warning
• Only use certified cleaning products suitable for
automotive glass and rubber. Improper use may
cause damage or stains, leading to glare on the
windshield glass.
Warning
• Install only front wiper blades identical to the
original equipment. Using inappropriate wiper
blades may damage the wiper system and affect
the operation of the rain sensor.
• When replacing front wiper blades, place a cloth or
old clothing at the contact point between the wiper
blade and the front windshield glass. This prevents
potential damage to the front windshield glass
caused by the wiper arm automatically snapping
back when removing the front wiper blade.
Replacing rear wiper blade
1. Turn off the wiper function.
2. Open the waterproof cover, useDriver’s Tool to
remove the fixing nut of the rear wiper blade.
* The image is for reference only; please refer to the actual
product
3. After removing the old rear wiper blade, install the
new rear wiper blade.
Caution
Replacing the wiper blades requires relevant
knowledge, experience, appropriateDriver’s Tool, or
equipment. Please seek assistance from the dealer.
Clean the wiper nozzles
* The image is for reference only; please refer to the actual
product
The position of the wiper nozzles is set at the factory and
does not require further adjustment.
If the wiper nozzles are blocked, useDriver’s Tool to clear
any obstacles.