178 丨 Maintenance and Care
Cleaning the Vehicle and Paint Maintenance
Vehicle Cleaning
When cleaning the vehicle, activate the Wash Mode (refer
to page 143) and pay attention to the following points:
• Due to dirt, dust, etc., adhering to the paint surface,
which may damage the paint, vehicles need regular
cleaning.
• Please use Vehicle washingDriver’s Tool and water to
wash off the dirt from the vehicle.
• Do not clean the vehicle while it is powered on.
• Do not water wash the interior of the front nacelle.
• Before cleaning the exterior of the vehicle, please
close all Windowss.
• Do not use acidic cleaning agents to clean the
vehicle. Acidic liquids may damage the vehicle's
surface, affecting its appearance.
• Do not use strongly alkaline soaps, powerful
chemical detergents, fuel, or solvents to clean the
vehicle, as it may affect the vehicle's appearance.
• In areas where roads are salted in winter, regularly
clean the underside of the vehicle to prevent salt
accumulation, which can accelerate corrosion of
the undercarriage and suspension.
• After washing the vehicle, wipe the vehicle's
surface clean to prevent residual cleaning agents
from corroding the vehicle's appearance.
High-Pressure Washing
When using a high-pressure water gun to clean the
vehicle, please follow the operating instructions:
● Before washing the Vehicle, check and confirm that
the external openings and closures of the vehicle are
properly secured.
● During vehicle cleaning, avoid directing the water gun
towards the bottom connectors for rinsing.
● Avoid using high-pressure washers or steam cleaners
to clean sensors to prevent sensor damage. When
cleaning the vehicle, use a small water flow for a short
time to rinse the surface of radar or cameras,
maintaining a distance of at least 10cm.
● Strictly follow the instructions for using high-pressure
washers to clean the vehicle, paying special attention
to working pressure and spraying distance. If using a
pressure washer, maintain a distance of at least
30cm between the nozzle and the surface of the
body. Keep the nozzle moving and avoid continuously
spraying water at one spot, as high-pressure water
entering vehicle components may cause damage.
Wheel Rims
Use a soft brush to clean the wheel rims and rinse with a
water gun.
Avoid using hard brushes, wire brushes, or
similarDriver’s Tool to scrub wheel rims to prevent
damage to the paint on the wheel rims.
Paint Maintenance
Regular waxing helps protect the paint and contributes to
maintaining the appearance of a new Vehicle.
Waxing does not restore the gloss of the Vehicle paint.
Cleaning Front and Rear Seats Belts
Use a sponge dipped in neutral soapy water to wipe the
Front and Rear Seats belts. After wiping, place the Front
and Rear Seats belts in a cool place to dry before use.
Front and Rear Seats belts should only be cleaned
inside the Vehicle and should not be disassembled
casually.
Cleaning Vehicle Lights
Clean Vehicle lights with water, a gentle cleaning agent,
and a soft cleaning tool at room temperature.
• Avoid using dry cloth, sponge, or other dry items
to clean the Vehicle lights to prevent scratching.
• Do not wax or polish the surface of the Vehicle
lights to avoid damage.
• Do not use cleaning agents directly on the Vehicle
lights in high temperatures; first, rinse with water
to cool them down before cleaning.
• Do not use alcohol or organic cleaning agents
(such as adhesive removers, glass cleaners, paint
cleaners, foam cleaners, diluents, de-icers, etc.) to
clean the Vehicle lights to prevent damage.
Screen Cleaning Mode
You can activate the screen cleaning mode by clicking
the screen cleaning mode button in the regular Wash
Mode interface, turning the screen black. In screen
cleaning mode, long-press the exit button for 3 seconds to
return to regular Wash Mode. Additionally, you can enable
screen cleaning mode through system settings > display
path.
To Next Page
Loading...
