SERES 5 - Wiper

82 丨 Vehicle Controls
Wiper
Front Windshield Wiper
The front windshield wiper is used to wipe away rainwater
on the front windshield, keeping the front windshield clean
and enhancing driving safety.
* The image is for reference only; please refer to the actual
product
● "1X" Mode: The front windshield wiper performs one
single swipe.
● "OFF" Mode: Default mode, the front windshield
wiper function is not active.
● "AUTO" Mode: The wiper control lever is in this
mode, and when rain is detected by relevant sensors,
the front windshield wiper automatically swipes.
● "1" Mode: Front windshield wiper continuous low-
speed wiping.
● "2" Mode: Front windshield wiper continuous high-
speed wiping.
* The image is for reference only; please refer to the actual
product
The sensitivity of the "AUTO" mode can be adjusted using
the wiper sensitivity switch in the middle, adjusting from
bottom to top increases sensitivity.
Caution
• Before using the front windshield wiper, please
clear any ice and snow from the front windshield
and ensure that the wiper blades are not frozen.
• If there are water streaks or stains on the front
windshield, it is necessary to clean both the front
windshield and the front wiper blades. If the issue
persists, consider replacing the front wiper blades
with new ones.
• Please refrain from using the wiper function on the
front windshield when it is dry.
Rear Windshield Wiper
The rear windshield wiper is used to wipe away rainwater
on the rear windshield, keeping the rear windshield clean
and enhancing driving safety.
Activate or deactivate the rear windshield wiper
* The image is for reference only; please refer to the actual
product
● Turn the rear wiper wash control knob to the " "
position: The rear windshield wiper is operational.
● Turn the rear wiper wash control knob to the "OFF"
position: The rear windshield wiper is turned off.
Caution
• Before using the rear windshield wiper, please
clear any ice and snow from the rear windshield
and ensure that the rear wiper blades are not
frozen.
• If there are water streaks or stains on the rear
windshield, it is necessary to clean both the rear
windshield and the rear wiper blades. If the issue
persists, consider replacing the rear wiper blades
with new ones.
• Please refrain from using the wiper function on the
rear windshield when it is dry.