46
Manual – Controllers DHE/DHF/DHR21B (standard) and DHE/DHF/DHR41B (advanced)
4
Installing the DHR21B/41B option
Assembly and Installation Notes
You can now access the inverter via the IP address 192.168.10.4. Proceed as follows
to set new IP address parameters:
• Start MOVITOOLS
®
MotionStudio.
• Select the required address parameters.
• On the DHR21B/41B option, set DIP switch "2
0
" to "0" (= left = OFF).
• The new address parameters are adopted after the unit is switched off and switched
on again.
4.9.8 LEDs in EtherNet/IP and Modbus/TCP mode
LEDs L13 and L14 of the DHR21B/41B indicate the current state of the DHR21B/41B
option and the EtherNet/IP or Modbus/TCP system.
LED L13 LED L13 (NETWORK STATUS).
LED L14 LED L14 (MODULE STATUS).
State of the L13 LED Meaning
Off The DHR21B/41B option does not yet have any IP parameters.
Flashing green/red The DHR21B/41B option card performs an LED test.
Flashing green There is no controlling IO connection.
Green There is a controlling EtherNet/IP IO connection.
Red Conflict detected in the assigned IP addresses. Another station in the network
uses the same IP address.
Flashing red The previously established controlling IO connection is in timeout state. The
state is reset by restarting communication.
State of the L14 LED Meaning
Off The DHR21B/41B option is not supplied with voltage or is defective
Flashing green • If the NETWORK STATUS LED is off at the same time, the TCP/IP stack of
the DHR21B/41B option will be started. If this state persists and DHCP is
activated, the DHR21B/41B option will wait for data from the DHCP server.
• If the NETWORK STATUS LED is flashing green at the same time, the
application of the DHR21B/41B option is started.
Flashing green/red The DHR21B/41B option performs an LED test.
Green Indicates the standard operating state of the DHR21B/41B option
Red The DHR21B/41B option is in fault state.
Flashing red Conflict detected in the assigned IP addresses. Another station in the network
uses the same IP address.
To Next Page
Loading...
