Manual – Controllers DHE/DHF/DHR21B (standard) and DHE/DHF/DHR41B (advanced)
53
5
Connection mode
Project Planning and Startup with MOVITOOLS
®
MotionStudio
5.3.2 Selecting the communication mode (online or offline)
Proceed as follows to select the communication mode:
1. Select the communication mode:
• "Switch to online mode" [1] for functions (online tools) that should directly
influence the unit.
• "Switch to offline mode" [2] for functions (offline tools) that should influence your
project.
2. Select the unit node.
3. Right-click to open the context menu and display the tools for configuring the unit.
INFORMATION
• The "online" communication mode is NOT a response message which informs
you that you are currently connected to the unit or that your unit is ready for
communication. Should you require this feedback, observe section "Setting the
cyclical accessibility test" in the online help (or the manual) of
MOVITOOLS
®
MotionStudio.
• Project management commands (such as download and upload), the online unit
status, and the unit scan work independent of the set communication mode.
• MOVITOOLS
®
MotionStudio starts up in the communication mode that you set
before you closed down.
9007200389198219
[1] "Switch to online mode" icon
[2] "Switch to offline mode" icon
[1] [2]
To Next Page
Loading...
