64
Manual – Controllers DHE/DHF/DHR21B (standard) and DHE/DHF/DHR41B (advanced)
5
Communication via Ethernet
Project Planning and Startup with MOVITOOLS
®
MotionStudio
5.5.4 Setting communication parameters for SMLP
Proceed as follows to set the Ethernet communication parameters:
1. Change the set communication parameters if necessary. Refer to the detailed
description of the communication parameters for SMLP.
NOTE: During a unit scan, the system recognizes only units that are in the same
(local) network segment as the PC that is running on MOVITOOLS
®
MotionStudio. If
you have units that are outside the local network segment, add the IP addresses of
these units to the list of SMLP servers.
2. Add an IP address by opening the context menu and selecting [Add IP address] [1]..
3. Enter the IP address in the input field [2] and click the [OK] button.
18014399832166155
[1] [Add IP address] button
[2] "IP address" input field
To Next Page
Loading...
