60
Manual – Controllers DHE/DHF/DHR21B (standard) and DHE/DHF/DHR41B (advanced)
5
Communication via Ethernet
Project Planning and Startup with MOVITOOLS
®
MotionStudio
3. Wait for the network scan to start automatically. The default setting for the waiting
time (scan timeout) is 3 s [2]
Note: If you no units are detected during the network scan, the wiring might be
inadequate, or you have several network cards installed (activated) in your PC.
In this case, proceed as follows:
• Select the required card. To do so, click "Select network card" [3] in the toolbar.
• Start the network scan manually. To do so, click "Start network scan" [1] in the
toolbar.
As a result, the current addresses of all Ethernet stations in the connected network
will be displayed.
4. Mark the "Localize" checkbox [4] to localize an Ethernet station.
The link/act LED of the first Ethernet interface of the respective Ethernet station will
flash green.
9007200768267787
[1] "Start network scan" icon
[2] "Scan timeout" edit box
[3] "Select network card" icon
[4] "Localize" checkbox
To Next Page
Loading...
