Manual – IPOSplus®
143
13
First steps
Compiler – Editor
13.2 First steps
This description is intended to help you familiarize yourself with the programming of the
IPOS
plus®
Compiler as quickly as possible. You are given an introduction into the basic
functions of the Compiler by means of an example which is created and developed step-
by-step from one chapter to the next.
This introduction is based on the assumption that you are familiar with a conventional
Windows operating system and standard Office applications.
The introduction comprises the following 4 steps:
Step 1: Starting IPOS
plus®
Compiler with MOVITOOLS
®
MotionStudio
This section illustrates the basic steps for starting the IPOS
plus®
Compiler via
MOVITOOLS
®
MotionStudio.
Step 2: Creating a new project
This section illustrates the IPOS
plus®
Compiler user interface provides information on
how to create a new IPOS
plus®
project.
Step 3: The first IPOS
plus®
program
This section is to assist you in creating your first IPOS
plus®
program.
Step 4: Compiling and starting the IPOS
plus®
program
In this chapter, you will compile the program you created in step 3, load it into
MOVIDRIVE
®
and run the program.
13.2.1 Step 1: Starting IPOS
plus®
Compiler with MOVITOOLS
®
MotionStudio
Requirements The IPOS
plus®
Compiler is integrated in the MOVITOOLS
®
MotionStudio software pack-
age.
The following conditions have to be fulfilled before you can start the IPOS
plus®
Compiler
via MOVITOOLS
®
MotionStudio:
• MOVITOOLS
®
MotionStudio 5.40 or later is installed on your PC.
• The device you want to create an IPOS
plus®
program for is connected to your PC.
Use a suitable interface adapter.
MOVITOOLS
®
MotionStudio and
creating a project
Proceed as follows to start MOVITOOLS
®
MotionStudio and create a project:
1. Start the MOVITOOLS
®
MotionStudio from the Windows start menu via:
[Start]/[Programs]/[SEW]/[MOVITOOLS-MotionStudio]/[MOVITOOLS-MotionStudio]
2. Create a project with a name and directory.
To Next Page
Loading...