SEW-Eurodrive IPOS plus - Designated Use; Target Group; Programming Errors

Manual – IPOSplus®
17
2
Designated use
Safety Notes
2.2 Designated use
Use the positioning and sequence control system with IPOS
plus®
for the following units
from SEW-EURODRIVE GmbH & Co KG:
•MOVIDRIVE
®
B
•MOVITRAC
®
B
•MQx
In addition, the following discontinued products support IPOS
plus®
:
•MOVIDRIVE
®
A
•MOVIDRIVE
®
compact
•MOVITRAC
®
07
2.3 Target group
The IPOS
plus®
user is a qualified person has been trained accordingly.
SEW-EURODRIVE recommends that the user attends additional product training
courses for units and motors that are programmed with IPOS
plus®
.
Any work related to installation, startup and maintenance of the devices as well as trou-
bleshooting may only be performed by qualified personnel. Observe IEC 60364 and
CENELEC HD 384 or DIN VDE 0100 and IEC 60664 or DIN VDE 0110 as well as the
national accident prevention regulations.
Qualified personnel in the context of these basic safety notes are persons familiar with
installation, assembly, startup and operation of the product who possess the required
qualifications.
All work in further areas of transportation, storage, operation and waste disposal must
be carried out by qualified personnel who are appropriately trained.
2.4 Programming errors
The IPOS
plus®
positioning and sequence control system allows you to adjust the
IPOS
plus®
units to meet the exact specifications of your application. As with all position-
ing systems there is, however, the risk of a programming error, which may result in un-
expected (although not uncontrolled) system behavior.