Sharp el-9950 - Page 113

112
Chapter 4: Graphing Features
The following illustration shows these relationships.
• Thesplitscreenisalwaysinthetracemode.Therefore,the
cursorpointerappearsonthegraph.Accordingly,thecoordinate
values are displayed reverse in the table and in the equation at
which the cursor pointer is located is also displayed reversely.
• Using
;
or
'
,movethecursoralongthegraph.(Values
displayed reverse in the table are also changed accordingly.)
• Whentwoormoregraphsaredisplayedonthescreen,the
desired graph is selected using
{
or
}
. (The table or
equation on the right of the screen is also changed accordingly.)
• Thetableonthesplitscreendoesnotrelatetothetablesettings
onthefull-screentable.
• Thetableonthesplitscreenisdisplayedinunitsoftrace
movement amount based on the cursor pointer position on the
graphscreen.Whenthefull-screentableisdisplayedbypressing
t
, a different table may appear on the screen.
• WhentheEXPRESorY’issettoONontheFORMATmenu,the
equation or coordinates are displayed on the graph screen.
• Onlyequationstobegraphedaredisplayedonthesplitscreen.
• Press
G
or
t
onthesplitscreentodisplaythefull-
screen of the graph or table. To exit the split screen, press any of
other function keys.
Y
G
GY
G@ "
Y@ "
@ "