Sharp el-9950

206
Chapter 11: Programming Features
2. Programming Hints
Editing the
program
Adding com-
mands, strings or
command lines
to the program
Entering
alphabetical
characters
(uppercase only)
Inputting
commands
Storing a
program line by
line
Blank line
Deleting a line
Deleting
command or
strings
Deleting an
entire program
Copying a line to
another location
Changing the
program name
Re-executing the
program
Press
P
B
and then the appropriate numbers to open the
stored program.
Press
@
i
to enter the insert type mode.
Press
E
to go to the next line. Be sure to press
@
i
again to turn off the insert type mode and return to type over mode.
Press
E
twice to insert a blank line.
Press
A
toentercharacters.Press
@
.
to use an
ALPHA-LOCKmodetoinputaseriesofalphabeticalcharacters.
In general, only a single command can be input per line.
Afterpressing
E
,
}
or
{
, the line will be stored in
memory. Otherwise, it is not stored. Be sure to store the all lines by
pressing
E
(
{
or
}
) before quitting editing (pressing
@
q
).
Blanklinesareignoredduringexecution.Youcanincludeblank
lines to gain better readability.
Move the cursor to the line you wish to delete and press
C
.
Move the cursor to on or after the letter you wish to delete and
press
D
or
B
, respectively.
Press
@
p
and use C DEL.(SeeChapter12OPTION
Menu).
Press
P
H
intheprogrameditmode.(Seepage216for
details)
Press
{
to move the cursor to the program name field. Enter
the new name and press
E
or
}
.
Pressing
E
again after execution of the program completes.
Press
O
or
@
q
to break the execution process.
Break the
execution
process