Sharp el-9950 - Page 61

60
Chapter 3: Manual Calculations
e
 Recallsthepreviousentry.Thisisusefulwhenyouwanttomodify
the previous entry, rather than reenter the whole expression over.
Example
• Calculate4
×
6.
4
|
6
E
 Next,calculate4
×
8.
@
e
B
8
E
Note: Executed expressions are stored in a temporary memory in the
executed order. If the temporary memory is full, the oldest data is
automatically deleted. Be aware that
e
may not function on
these occasions.
  Amaximumof160bytescanbestoredinthetemporarymemory.
The capacity may vary when there are division codes between
expressions.
  Whenswitchingfromequationeditmodetoone-lineeditmodein
theSETUPmenu,allthenumericalandgraphequationsstoredin
the temporary memory are cleared and cannot be recalled.
$
 Enters“pi”.Piisamathematicalconstant,representingtheratioof
the circumference of a circle to its diameter.
Example
• Enter“2
π
”.(=6.283185307)
2
@
$
E
j
 CallsuptheCATALOGmenu.FromtheCATALOGmenu,youcan
directly access various functions in the menus.
• Functionsarelistedinalphabeticorder.
• Movethecursorusingthe
{
/
}
keys and press
E
to access or enter the function.
• Press
A
andanappropriatealphabetickey(AtoZ)to
navigate the catalog.
• Press
A {
/
A }
to scroll the catalog page
by page and press
@ {
/
@ }
tojumptothe
beginning or the end of the catalog.
• ThefunctionsaccessibleonlyfromtheCATALOGmenuare:
→
a
b/c,
→
A.
xxx
,
→
b/c,
e
, int÷, remain, rndCoin, rndDice,
Simp, %.
Pleaserefertothefollowingexplanation.