Sharp el-9950 - Page 99

98
Chapter 4: Graphing Features
2. Press
A
to select A DRAW, then press
0
2
to select 02 Line(.
 TheGRAPH
window reappears,
with the coordinate
of the cursor
showing at the
bottom of the
screen.
Note: To change the cursor coordinate system, use the
FORMATmenu.SelectF CURSOR, then select the
required coordinate system for the cursor.
3. Move the flashing cursor on the screen to set the
starting point of the line.
Note: ThepixelincrementcanbesetwithintheZOOMmenu.
While A ZOOM is selected, choose 7 Dec to set each
pixelsizeto“0.1
×
0.1”,or8 Int to set to “1
×
1”.
4. When the starting
point is set, press
E
to anchor
the location.
5. Move the cursor
to indicate the end
point of the line.
When set, press
E
tonalize
the line drawing.
6. Youmaydrawasmanylinesasyouwish,by
repeating the procedure from 4 to 5. When done
drawing, press
C
to exit the entry mode.