2-12
COPIERâ–ºBEFORE USING THE MACHINE AS A COPIER
SELECTING THE PAPER TRAY FOR
COPYING
The machine is set to automatically select the tray with the size of paper that is the same as the set original size. (Auto
Paper Select).
If the original size cannot be detected correctly because it is a non-standard size or when you want to change the paper
size for copying, you can select the paper tray manually.
If the selected tray runs out of paper during a copy job and there is another tray that has the same size and type of paper,
that tray will be automatically selected and the copy job will continue.
To change the initially selected tray:
In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Initial Status Settings] → [Paper Tray].
1
Tap the [Paper Select] key.
â–º COPYING SEQUENCE (page 2-7)
2
Tap the required tray key.
After the settings are completed, tap .
In Easy mode In Normal mode
• When the bypass tray is selected, specify the paper type and size based on the paper loaded into the bypass tray.
• In normal mode, you can also open the [Paper Select] screen by tapping the machine image on the base screen.
To automatically select the tray, tap the [CA] key. When the [CA] key is tapped, all settings selected to that point are
cleared and you will return to the base screen.
8½x11
8½x11
8½x11
8½x11
8½x11
8½x11 8½x11
8½x11
8½x11
8½x11
8½x11
To Next Page
Loading...
Need help?
General
