1-55
BEFORE USING THE MACHINEâ–ºBEFORE USING THE MACHINE
UNIVERSAL DESIGN IN THE MACHINE
The structure of the machine and the software are designed to allow all people to use the machine with ease.
UNIVERSAL DESIGN RELATED TO OPERATION
Adjustment of operation panel angle
The angle of the entire operation panel can be adjusted to enable use even when seated.
Grip handle on paper trays
The grip-type handles allow easy use from above or below. By simply placing your hand on a handle and gently pulling
forward, a tray can be withdrawn. The trays can be manipulated in a natural manner.
Changing of key response time
The response time of the keys can be changed as needed.
In "Settings" (administrator)", select [System Settings] → [Common Settings] → [Operation Settings] → [Condition
Settings] → [Key Operation Setting].
• Time for Accepting Key Entry
This setting determines how long a key in the touch panel must be tapped until the key input is registered. The time
can be set from 0 to 2 seconds in increments of 0.5 seconds.
By lengthening the time setting, key input can be prevented when a key is tapped accidentally. Keep in mind,
however, that when a longer setting is selected more care is required when tapping keys to ensure that key input is
registered.
• Disable Auto Key Repeat
This is used to disable key repeat.
Key repeat causes a setting to change continuously not only each time the key is tapped but while a key is tapped.
• Long-touch Detection Time
Select a time when a long key touch is detected.
• Double Tap Speed Interval
Select an interval when a double tap is detected.
To Next Page
Loading...
Need help?
General
