2-113
COPIERâ–ºCONVENIENT COPY FUNCTIONS
PROGRAMS
Programs are set from the base screen of normal mode.
â–º SELECTING COPY MODE (page 2-4)
STORING A PROGRAM
This function collectively stores copy settings as one program. The stored program can be retrieved using an easy
operation.
For information about how to retrieve a program, see "RETRIEVING A PROGRAM (page 2-116)
".
For example, suppose 8-1/2" x 11" (A4) size CAD drawings are copied once a month for archive purposes using the
following settings:
• The 8-1/2" x 11" (A4) size CAD drawings are reduced to 5-1/2" x 8-1/2"(A5) size.
• To reduce paper use by half, 2-sided copying is used.
• To close by file, perform margin copy.
Programs cannot be stored in easy mode.
When a job program is not stored When a job program is stored
Set reduction from 5-1/2" x 8-1/2"(A5) to 8-1/2" x 11" (A4)
Change the exposure setting.
Set 2-sided copying.
Set margins.
Tap the [Start] key.
Retrieve the stored program.
Tap the [Start] key.
Considerable time is required to copy the drawings each
month because the above settings must be selected.
In addition, mistakes are occasionally made when selecting
the settings, so some copies must be redone.
The settings are stored in a program, so they can be selected
by the touch of a key. This is simple and takes no time.
In addition, the settings are all stored so there are no chances
for mistakes, and thus no need to redo copies due to setting
mistakes.
8-1/2" x 11" (A4) size CAD drawings
Copy
To Next Page
Loading...
Need help?
General
