7-126
SYSTEM SETTINGSâ–ºSYSTEM SETTINGS
Plain Paper Weight Settings
These are used to control the toner fusing temperature according to the weight of the paper.
These settings apply to plain paper, recycled paper, punched paper, pre-printed paper, letterhead paper, colored paper,
and user type paper
.
You can select "16 to 23 lbs." or "23+ to 28 lbs." ("60g/m
2
to 89g/m
2
" or "90g/m
2
to 105g/m
2
").
Data List
To specify [One Sided] or [Two Sided] printing in Data List.
Disabling of Duplex
This is used to disable 2-sided printing, such as when the duplex module malfunctions.
Disabling of Offset
Disable offset output.
Disabling of Document Feeder
Use this setting to prohibit the use of the automatic document feeder, such as when the feeder malfunctions. (When the
setting is enabled, scanning is still possible using the document glass.)
Disabling of Optional Paper Feed Unit
This setting is used to disable the optional paper feed unit, such as when it malfunctions.
Disabling of Tray Settings
This setting is used to prohibit tray settings (except for the bypass tray).
Disabling of Finisher
This setting is used to prohibit the use of inner finisher, such as when it malfunctions.
Disabling of Stapler
This setting is used to prohibit the use of staple, such as when the staple of inner finisher malfunctions.
This can only be set on the machine's operation panel.
Be sure to use only paper that is in the same weight range as the weight range set here. Do not mix plain or other paper that
is outside the range with the paper in the tray.
When settings are changed, the changes will take effect after the machine is restarted. To restart the machine, see
"TURNING ON THE POWER (page 1-8)
".
To Next Page
Loading...
Need help?
General
