2-86
COPIERâ–ºOTHER FUNCTIONS
Tracking Information Print Makes a stamp copy under a tracking information print.
Repeat Layout Cannot be combined.
Position Image Prints an image at the original position regardless of the Position Image setting.
• An image must be registered in advance from the printer driver to the machine.
â–º REGISTERING A CUSTOM IMAGE (page 3-48)
• A custom stamp image is copied by sheet, not by original. If N-Up is enabled, user stamps are copied for each set of
pages.
• A custom stamp image is copied with the registered size. The size remains unchanged even when the copy ratio is
enlarged or reduced.
• A different custom image cannot be specified for each page.
• If an image runs off of the specified paper depending on the registered size or position, the excess will not be copied.
1
Place the original.
Place the original in the document feeder tray of the automatic document feeder, or on the document glass.
â–º AUTOMATIC DOCUMENT FEEDER (page 1-75)
â–º DOCUMENT GLASS (page 1-77)
2
Tap the [Others] key, and tap the [Custom Image] key.
3
Tap the [Custom Stamp] or [Custom Watermark] key.
4
Tap the [Image] key to select an image.
Select the required thumbnail image(s) from the available selection.
5
Set [Print Page] or [Print Position].
After the settings are completed, tap and [Back] keys in
sequence.
• To cancel the custom image setting:
Tap the [Off] key.
• To cancel all settings:
Tap the [CA] key.
Combined function Custom image operations
8½x11
8½x11
Custom Image
Select Image to Operate.
Off
Image
Print Page
Print Position
Angle
Custom
Stamp
Custom
Watermark
Print on cover/insert when
0°
First Page
Not
X: 0 mm
Y: 0 mm
(3)
(4)
(5)
To Next Page
Loading...
Need help?
General
