5-107
SCANNER/INTERNET FAXâ–ºOTHER FUNCTIONS
4
Tap the [Others] key, and tap the [Blank Page Skip] key.
5
Tap the [Skip Blank Page] or [Skip
Blank and Back Shadow] key.
After the settings are completed, tap and [Back] keys in
sequence.
To cancel the Blank Page Skip setting:
Tap the [Off] key.
6
Tap the [Start] key to start scanning of the original.
A beep will sound to indicate that scanning has ended.
Tap the [Preview] key to check the preview of an image before sending a fax. For more information, see "CHECKING
THE IMAGE TO BE TRANSMITTED (page 5-66)".
7
When scanning ends, check the
number of original sheets and the
number of sheets to be sent and tap
the [OK] key to start transmission.
• When Job Build mode is used, the confirmation message
will appear after the [Start] key is tapped.
• On the confirmation screen, the number of scanned
original sheets appears in (A), the number of scanned
sides in (B), and the number of sheets to be sent
excluding blank pages in (C).
For example, if five original sheets that include two blank
pages are scanned by duplex scanning, (A) will show "5",
(B) will show "10", and (C) will show "8".
If this step is not performed within one minute after the above confirmation screen appears, the scanned image and
settings will be cleared and the base screen will reappear.
Scanning will not be completed automatically and the image will not be reserved for transmission.
Preview
Start
5 pages of original have (P.8)
been scanned. 10 sheets of original
will be Perform the job?
Cancel OK
8½x11 8½x11
(A)(C)
(B)
To Next Page
Loading...
Need help?
General
