Sharp MX-B355W

7-26
SYSTEM SETTINGS►SETTING MODE LIST
*1 This setting is configured in setting mode on the machine.
*2 This setting can be set in Server 1.
Common Settings
U: General user; A: System administrator/Administrator
• Check Interval 1min. No Yes
• Timeout 20 seconds No Yes
Setup Items Factory default setting U A
● Common Settings (page 7-118)
 Paper Settings Yes Yes
 Paper Tray Settings Yes Yes
• Auto Switching of Tray Enabled Yes Yes
• Display Paper Tray Settings when bypass tray
detects paper.
Enabled Yes Yes
• Tray 1 Plain 1, Auto-Inch (Auto-AB) Yes Yes
•Tray 2*
1
Plain 1, Auto-Inch (Auto-AB)
Yes Yes
•Tray 3*
1
Yes Yes
•Tray 4*
1
Yes Yes
• Bypass Tray Plain 1, A4 (8-1/2" x 11") Yes Yes
 Custom Size Registration (Bypass) Custom 1 to 7
Size Input-Inch
X=297mm (11") Y=210mm (8-1/2")
Yes Yes
 Paper Type Registration – Yes Yes
 Operation Settings No Yes
 Condition Settings No Yes
• Enlarge Display Mode Disabled No Yes
• Message Time Setting 6 sec. No Yes
• Language Setting American English No Yes
• Default Display Setting Home Screen No Yes
• Display Favorite Menus as Default Disabled No Yes
• Display Action Panel as default. Enabled No Yes
• Icon is displayed when network cable is not
connected.
Enabled
No Yes
• Display Confirmation Dialog when job is canceled. Disabled No Yes
• Switch the Number of Sets to be Displayed for Job
Status
Progress
No Yes
• Alignment Order of 10-Key Ascending order from upper left No Yes
Setup Items Factory default setting U A