7-85
SYSTEM SETTINGSâ–ºSYSTEM SETTINGS
Initial Status Settings
The following settings are related to copying.
Initial Status Settings selected with these settings apply to all functions of the machine (not just the copy function).
The copier settings are reset to the initial state when the [Power] button is turned on, when the [CA] key is tapped, or
when the auto clear interval has elapsed. These settings are used to change the default settings for copy mode.
The following settings can be changed:
Text /Image Printing
Text Settings (Stamp)
You can add fixed text used in the [Stamp] in [Others] of copying.
Custom Stamp
You can set an image to be used in [Custom Stamp] in [Custom Image] of [Others] for copying.
Custom Watermark
You can set an image to be used in [Custom Watermark] in [Custom Image] of [Others] for copying.
Item Description
Image Orientation Specify the original orientation.
Paper Tray Specify the paper tray that is selected by default.
Exposure Type Configure default exposure mode settings.
Copy Ratio Specify the copy ratio that is selected by default.
2-Sided Copy
Configure the 2-sided mode settings that are selected by default.
If this setting is used to change the default setting for the duplex function to any setting
other than "1-Side to 1-Side" and the duplex function or automatic document feeder fails or
is disabled, the setting will revert to "1-Side to 1-Side".
Original Binding Set the original binding in 2-Sided copy.
Output Binding Set the output binding in 2-Sided copy.
Output Set the print output method that are selected by default.
Staple Configure staple settings
Separator Page
Separator pages can be inserted before or after jobs. Set the paper tray used for the
separator pages.
Factory defaults This returns all items to the factory default settings.
To Next Page
Loading...
Need help?
General
