7-179
SYSTEM SETTINGSâ–ºSETTING MODE FOR FAX
Allow/Reject Number Setting
Use this setting to specify whether reception from a stored number is to be allowed or rejected.
Reject hidden Number
Rejects a call if the caller has blocked the sending of caller identification information.
Polling Setting
The following settings are for regular polling memory using the Public Box.
Set Fax Polling Security
When the memory polling function is used, this setting determines whether any machine will be allowed to poll your
machine, or only machines that have been stored in your machine.
Add New
When the Polling Security Setting is enabled, use this setting to store (or delete) the fax numbers of the machines that
are allowed to poll your machine. Up to 10 destination fax numbers can be stored. Each number must be within 20 digits
in length.
Passcode Number Key List
This shows a list of the stored passcode numbers. Select a number from the list and delete it.
Item Settings
Rejected Reject reception from the stored number.
Allow Reception Allow reception from the stored number.
All Invalid
Even if numbers have been stored, disregard the numbers and allow reception from all
numbers.
Add New
Adds a new address or domain (maximum of 50) from which reception is to be rejected or
allowed.
Enter the number (maximum of 20 digits) and tap the [Store] key.
Registration Number List
A list of the stored numbers can be displayed.
When you select a number from this screen, it is deleted from the list.
Reject hidden Number
If checked, any call from the number of Reject Unknown Calls setting is rejected,
regardless of the certain number receive settings.
When there are no stored anti junk mail addresses or domains, only the [Add New] key can be selected.
Note that these settings do not apply to F-code polling memory.
To Next Page
Loading...
Need help?
General
