Sharp MX-M700N - Page 100

MX-M700N SIMULATION 7 – 6
48 1 Magnification ratio adjustment (by Input/Output) {{
5 Motor speed adjustment {
49 1 Firmware update {{{
50 1 Copy lead edge adjustment (Document table) {{{
2 Lead edge adjustment (Document table simple type) {{{
5 Print lead edge adjustment {{
6 Copy lead edge adjustment (SPF) {{{
7 Copy lead edge adjustment (SPF simple type) {{{
10 Print off-center adjustment {{
12 Document off-center adjustment {{
27 Document image loss setting (FAX send/scanner mode) {
51 2 Resist amount adjustment {{
53 6 SPF size width detection level adjustment {
7 SPF size width detection adjustment value input {
8 SPF scan position adjustment {
55 1 Engine soft SW change and check {
2 Scanner soft SW change and check {
3 Controller soft SW change and check {
56 1 Data transfer {
60 1 ICU image DRAM read/write check {
61 1 LSU operation check {
2 Laser power setting (Copier) {
3 Laser power setting (FAX) {
4 Laser power setting (Printer) {
62 1 Hard disk format {
2 Hard disk read/write check {
3 Hard disk read/write check (All areas) {
6 HDD self diag {
7 Self diag error log print {
8 Hard disk format (Excluding the system area) {
9 HDD format (system area) {
10 Job complete list delete {
11 Document filing data delete {
63 1 Shading check {
2 Shading execution {
7 White plate scan start position adjustment {
64 1 Self print {
65 1 Touch panel adjustment {
2 Touch panel check {
Main
code
Sub
code
Operation content
Data save destination/Target
MFP Scanner Engine