Sharp MX-M700N - Page 101

MX-M700N SIMULATION 7 – 7
66 1 FAX-related soft SW setting check/change {
2 FAX-related soft SW clear (Excluding FAX adjustment values) {
3 FAX-related memory check {
4 Signal send mode (Signal send level: Max.) {
5 Signal send mode (Signal send level: Soft SW setting) {
6 Confidential pass code print {
7 Image memory content output {
8 Voice message reproduction (Signal send level: Max.) {
9 Voice message reproduction (Signal send level: Soft SW setting) {
10 Image memory clear {
11 300bps signal send (Signal send level: Max.) {
12 300bps signal send (Signal send level: Soft SW setting) {
13 Dial number registration {
14 Dial test (10PPS make time setting & delivery test) {
15 Dial test (20PPS make time setting & send test) {
16 Dial test (DTMF signal adjustment & send test) {
17 DTMF signal send mode (Signal send level: Max.) {
18 DTMF signal send mode (Signal send level: Soft SW setting) {
19 Address book backup (WR TO FLASH) {
20 Address book backup (RD FROM FLASH) {
21 FAX information print {
23 FAX program download {
24 FAST memory data clear {
25 MODEM dial-in FAX number registration {
26 MODEM dial-in telephone number registration {
27 Voice warp transfer destination registration {
29 Address book clear {
30 TEL/LIU status change check {
31 TEL/LIU setting {
32 Receive data check {
33 Signal detection check {
34 Communication time measurement display {
35 MODEM program rewrite {
36 MFP controller I/F check {
39 FAX destination registration {
42 Reload of the PIC program {
43 Setting of the PIC adjustment value {
60 (Secret) ACR data registration {
67 16 Network card check {
Main
code
Sub
code
Operation content
Data save destination/Target
MFP Scanner Engine