MX-M700N SIMULATION 7 – 27
26-5
Purpose
Setting
Function (Purpose)
Used to set the count mode of the total
counter and the maintenance counter.
Section
—
Operation/Procedure
1) Select the number corresponding to the counter to be set with
10-key.
2) Press the [START] key.
3) Select the count mode with 10-key.
4) Press the [START] key.
Set the count-up (1 or 2) for A3/11x17 paper.
(Select the target counter.)
(Count-up)
26-6
Purpose
Setting
Function (Purpose)
Used to set the specifications (paper, fixed
magnification ratio, etc.) of the destination.
Section
—
Operation/Procedure
1) Select the number corresponding to the destination with 10-
key.
2) Press the [START] key.
After completion of setting, the machine is automatically reset.
Since this simulation cannot change the Fax destination, use SIM
66-2 to change the FAX destination.
26-10
Purpose
Setting
Function (Purpose)
Used to set the network scanner trial mode.
Section
—
Operation/Procedure
1) Select START/END of the network scanner trial mode with 10-
key.
2) Press the [START] key.
Max. 500 images can be scanned.
(Default: 0)
26-18
Purpose
Setting
Function (Purpose)
Used to set YES/NO of toner save opera-
tion. (This function is valid only in Japan
and UK versions. (Depends on the destina-
tion setting of SIM26-6.) For the other desti-
nations, the same setting can be made by
the user program P22.)
Section
—
Operation/Procedure
1) Select YES/NO of the toner save mode with 10-key.
2) Press the [START] key.
(Default: 1)
1 TOTAL COUNTER Total counter
2 MAINTENANCE
(DRUM) COUNTER
Maintenance counter/ OPC drum counter
3 DV COUNTER Developer counter
1 1 COUNT UP 1 count-up
2 2 COUNT UP 2 count-up Default
1 USA United States of America
2 CANADA Canada
3 INCH Inch series EX
4 JAPAN Japan
5 AB_B AB series B5
6 EUROPE Europe
7UK UK
8 AUSTRALIA Australia
9 AB_A AB series A5
10 CHINA China
SIMULATION 26-3
AUDITOR SETUP. SELECT 1-3, AND PRESS START.
1. P10
2. VENDOR
3. OTHERS
4. VENDOR-EX
5. VENDOR-EX +
6. VENDOR-EX (MULTI JOB)
7. VENDOR-EX +(MULTI JOB)
1
SIMULATION 26-5
1
A3(LEDGER) COUNT UP MODE SETTING. SELECT 1-3, AND PRESS
START.
1. TOTAL COUNTER 1
2. MAINTENANCE(DRUM) COUNTER 1
3. DV COUNTER 1
0 END Trial mode cancel
1 START Trial mode start
0 YES set.
1 NO not set.
SIMULATION 26-6
DESTINATION SETUP. SELECT 1-10, AND PRESS START.
1.USA 2.CANADA 3.INCH
4.JAPAN 5.AB_B
6.EUROPE 7.UK 8.AUSTRALIA
9.AB_A 10.CHINA
1
SIMULATION 26-10
NETWORK SCANNER TRIAL SETTING. SELECT 0-1, AND PRESS
START.
0.END
1.START
1
SIMULATION 26-18
TONER SAVE MODE SETTING. SELECT 0-1, AND PRESS START.
0. YES
1. NO
1
To Next Page
Loading...
