MX-M700N SIMULATION 7 – 29
26-52
Purpose
Setting
Function (Purpose)
Used to set whether non-print paper (inser-
tion paper, cover paper) (blank image print
paper) is counted up or not.
Section
Paper transport
(Paper exit/Switchback/Transport)
Operation/Procedure
1) Select YES/NO of the non-print paper count-up with 10-key.
2) Press the [START] key.
Non-print paper means an insert paper (without copying) in the
OHP insertion mode, a cover (without copying) in the cover inser-
tion mode, back surface, and white paper in the duplex exit mode
(CA, etc.).
(Default: 0 for Japan and Australia, 1 for the other)
The target counters are as follows:
• Copies counter
• Printer counter
• Department management counter
• Total counter
• Valid paper counter
26-68
Purpose
Setting
Function (Purpose)
Used to set ENABLE/DISABLE of the CA
key cancel function of print stop.
Section
—
Operation/Procedure
1) Select ENABLE/DISABLE of the CA key cancel function of
print stop with 10-key.
2) Press the [START] key.
(Default: 1)
27
27-1
Purpose
Setting
Function (Purpose)
Used to set the specifications for opera-
tions in case of communication trouble
between the host computer and MODEM
(machine side). (When communication
trouble occurs between the host computer
and MODEM, the self diag display (U7-00)
is printed and setting for inhibition of print or
not is made.)
Section
Communication unit
(RIC/MODEM etc.)
Operation/Procedure
1) Select the number corresponding to the operation mode with
10-key.
2) Press the [START] key.
(Default: 0)
27-5
Purpose
Setting
Function (Purpose)
Used to enter the machine tag No. (This
function allows to check the tag No. of the
machine with the host computer.)
Section
Communication unit (RIC/MODEM etc.)
Operation/Procedure
1) Enter the tag number with 10-key.
2) Press the [START] key.
0 NO (NO COUNT UP) No count up
1 YES (COUNT UP) Count up
0 DISABLE Disable
1 ENABLE
(PRINT STOP)
Enable
SIMULATION 26-52
BLANK PAPER COUNT UP SETTING. SELECT 0-1, AND PRESS
START.
0. NO (NO COUNT UP)
1. YES (COUNT UP)
1
SIMULATION 26-68
CA KEY CANCEL MODE SETTING. SELECT 0-1, AND PRESS
START.
0. DISABLE
1. ENABLE (PRINT STOP)
0
0 YES Though a communication trouble occurs
between the host computer and the MODEM
(machine side), there is no effect on the
machine operations.
1 NO When a communication trouble occurs between
the host computer and the MODEM (machine
side), the self diag display (U7-00) is displayed
and printing is inhibited.
SIMULATION 27-1
DISABLING OF U7-00 TROUBLE. SELECT 0-1, AND PRESS START.
0. YES
1. NO
1
SIMULATION 27-5
TAG # SETTING. INPUT VALUE, AND PRESS START.
PRESENT: 00010000
NEW: 00009999
To Next Page
Loading...
