MX-M700N PAPER EXIT SECTION O – 6
j. Paper exit detector 3
1) Remove the paper exit unit. (See “(1) Paper exit unit”)
2) Remove the upper cover. (See “c. Fusing cooling fan motor 1”)
3) Disconnect the connector, and remove the harness protect
sheet. Remove the paper guide.
4) Remove the cover, and the remove the paper exit detector 3.
k. Paper exit roller 2
1) Remove the paper exit unit. (See “(1) Paper exit unit”)
2) Remove the upper cover. (See “c. Fusing cooling fan motor 1”)
3) Remove the paper guide. (See “j. Paper exit detector 3”)
4) Remove the ground plate. Remove the E-ring to remove the
bearing.
5) Remove the E-ring, and the gear. Remove the spring pin and
the bearing.
6) Remove the paper exit roller 3.
To Next Page
Loading...
