Sharp MX-M700N - Page 390

MX-M700N DRIVE SECTION P – 10
(2) Others
a. Remove the paper tray lift-up motor (paper feed tray 1)
1) Remove the rear cabinet.
2) Remove the plastic E-ring, the belt holding sheet, the belt, and
the pulley.
* When installing, be careful of the direction of the belt holding
sheet.
3) Disconnect the connector, and remove the lift-up motor unit.
4) Release the pawl, and remove the lift-up coupling. Remove the
liftup spring from the paper tray lift-up motor.
b. Paper tray lift-up motor (Paper feed tray 2)
1) Remove the high voltage PWB unit.
(See “D-(1) Manual paper feed drive unit”)
2) Disconnect the connector, and remove the lift-up motor unit.
3) Release the pawl, and remove the lift-up coupling. Remove the
liftup spring from the lift-up motor.
c. Paper pickup solenoid (Paper feed tray 2)
1) Remove the high voltage PWB unit.
(See “D-(1) Manual paper feed drive unit”)
2) Disconnect the connector, and remove the paper pickup sole-
noid unit.
3) Remove the paper pickup solenoid.
* When installing, check that the solenoid plunger is inserted
in the arm.