MX-M700N PWB SECTION Q – 3
(7) HDD
1) Remove the cooling fan motor unit.
(See “(5) Controller cooling fan motor”)
2) Disconnect the connector, and remove the HDD unit.
3) Remove the HDD slide plate, and remove the HDD mounting
plate from the HDD.
(8) Soft NIC PWB
1) Remove the right cabinet upper.
2) Pull out the NIC control unit.
3) Remove the soft NIC PWB unit.
4) Remove the soft NIC PWB angle from the soft NIC PWB.
(9) MFP FLASH ROM PWB
1) Pull out the NIC control unit. (See “(8) Soft NIC PWB”)
2) Release the lock, and remove the MFP Flash PWB.
(10) MFP controller PWB
1) Remove the manual feed cover F, the right cabinet middle,
and the right cabinet upper. (See “(8) Soft NIC PWB”)
2) Pull out the NIC control unit, and remove the flat cable.
Release the lock, and remove the NIC control unit.
To Next Page
Loading...
