Sharp MX-M700N - FAN AND FILTER SECTION; [R] FAN AND FILTER SECTION; Fan Motor Disassembly;Assembly

MX-M700N FAN AND FILTER SECTION R – 1
MX-M700N
5GTXKEG/CPWCN

[R] FAN AND FILTER SECTION
1. Disassembly and assembly
A. Fan motors
(1) Developing section cooling fan motor
1) Remove the rear cabinet.
2) Disconnect the connector and remove the harness clamp.
Remove the DV fan unit.
3) Disconnect the connector, and remove the DV fan.
(2) Paper cooling fan motor
1) Remove the rear cabinet and the rear cabinet upper.
2) Disconnect the connector, and remove the paper cooling fan
motor.
* When installing, arrange so that the arrow mark on the side
of the duct faces in the same direction with the arrow mark
on the side of the fan.
No. Parts
(1) Developing section cooling fan motor
(2) Paper cooling fan motor
(3) Fusing cooling fan motor 2
(4) Process exhaust fan motor 5
(5) Process exhaust fan motor 4
(6) Process exhaust fan motor 1
(7) Process exhaust fan motor 2
(8) Process exhaust fan motor 3
(9) Process cooling fan 1
(10) Process cooling fan 2
(11) Process cooling fan 3
(1)
(2)
(4)
(5)
(3)
(8)
(7)
(6)
(9)
(
11)
(
10)
Fan blowing direction
Fan blowing direction