MX-M700N FAN AND FILTER SECTION R – 2
(3) Fusing cooling fan motor 2
1) Remove the rear cabinet.
(See “(1) Developing cooling fan motor”)
2) Remove the tray.
3) Remove the left cover cabinet.
4) Open the left door.
5) Remove the left cabinet upper.
6) Disconnect the connector, and remove the paper exit rear duct
unit.
7) Disconnect the connector, and remove the fusing cooling fan
motor.
* Be careful of the direction of the fan.
(4) Process exhaust fan motor 5
1) Remove the rear cabinet.
(See “(1) Developing cooling fan motor”)
2) Disconnect the connector and remove the harness clamp.
Remove the sub duct unit.
3) Disconnect the connector and remove the process exhaust
fan motor 5.
* Be careful of the direction of the fan.
Fan blowing direction
REVERSE
Fan blowing direction
To Next Page
Loading...
